FAQ Search Results

A: Yes – the harness strap covers on the Rue LX Spin are removable at any time.

A: Yes – you can buy an additional base for the Rue LX car seat via joiebaby.com.

A: Yes – you can install Rue LX Spin in the center seat of your vehicle. Please check in your vehicle owner’s manual as to whether you have lower anchors for your center seating position. If there aren’t dedicated lower anchors for your center seat, install the Rue LX Spin with the seatbelt.

A: This will largely depend on your vehicle make and model, type of car seats in question, the type of vehicle seat belts in use, and the configuration of the seat cushion. While the Rue LX Spin is relatively narrow, the only way to know for sure is to install the car seat next to the adjacent car seats or passengers. 

 

When installing three car seats next to each other, please make sure the following conditions are met:

 

  • Each car seat must achieve a correct and tight installation.
  • The positions of the car seat on the vehicle seat are not changed by contact. Each car seat still aligns properly with respect to the seat belt or lower anchors that secure them and do not overlap the adjacent car seat.
  • If the vehicle seat is adjustable front-to-back, both portions of the vehicle seat must be adjusted to the same position.
  • Only one lower anchor connector is connected to a single lower anchor point.
  • There is no contact or force that would bend or deform any of the car seats.
  • The lower anchor belt or seat belt used to install each car seat does not rub on each other or crossover in a way that they interfere with each other.

A: Yes – the Rue LX Spin carrier can be installed without the base using the vehicle seat belt. Please refer to your manual for step-by-step installation instructions.

A: You may continue to use your Rue after a minor accident.  A minor accident is defined as follows (all must apply):

 

  1. The vehicle was able to be driven away from the crash site.
  2. The vehicle door nearest the child restraint was NOT damaged.
  3. None of the passengers in the vehicle sustained any injuries in the crash.
  4. If the vehicle has air bags, the air bags did not deploy during the crash; and
  5. There is no visible damage to the child restraint.

 

If your accident does not meet all 5 conditions, it must be replaced.

A: Yes, the Rue LX Spin base should always be locked into the rear facing position before driving. The turn lock indicator on the side of the seat should be green.

A: No. The low birth weight pillow is optional, but best designed for use with children under 8 lbs. The infant insert can continue to be used without the low birth weight pillow inserted until the child reaches 11 lb.

A: No. Currently, we do not sell a travel bag for the Rue LX Spin. However Rue LX is  approved for airplane usage without the base using the lap belt. Please refer to your car seat’s manual for instructions on how to use on an airplane.

A: Yes – the Rue LX has a carrying handle.

A: There are three different positions for the harness straps.  At all times when rear-facing, the harness straps should come out of the car seat shell at or below your child’s shoulders.  If you need to move the straps up to the next position, you will need to remove baby from the seat, flip it over, remove the harness straps from the metal splitter plate, move them up to the next slot, and then re-attach the harness straps to the metal splitter plate.  Your car seat instruction manual has detailed instructions on how to do so with accompanying graphics.

A: The Rue LX car seat weighs approx. 8 lb. without the base. The Rue LX Spin base weighs approx. 14.33 lb.

A: If the recline foot is fully extended and still doesn’t get the recline indicator entirely under the blue line on the side of the seat, you can add a rolled-up towel under the edge of the car seat base near the vehicle seat bight. Please see your manual for detailed instructions.

A: Yes. If the Rue LX Spin isn’t level with the recline foot all the way out (position 4), you may store the recline foot fully and place a tightly rolled towel at the vehicle seat bight under the edge of the car seat and install following the instructions in your manual for a seatbelt installation.

A: No. Once the harness straps have been moved to the top position, the head support should be removed. The harness straps and the head support straps cannot go through the same slots in the shell of the seat.

loader
Loading...